Cisco Catalyst 2960 Series User Manual

The BPDU guard feature provides a secure response to invalid configurations because you must manually
put the interface back in service. Use the BPDU guard feature in a service-provider network to prevent an
access port from participating in the spanning tree.
Related Topics
Enabling BPDU Guard , on page 304
BPDU Filtering
The BPDU filtering feature can be globally enabled on the switch or can be enabled per interface, but the
feature operates with some differences.
Enabling BPDU filtering on PortFast edge-enabled interfaces at the global level keeps those interfaces that
are in a PortFast edge-operational state from sending or receiving BPDUs. The interfaces still send a few
BPDUs at link-up before the switch begins to filter outbound BPDUs. You should globally enable BPDU
filtering on a switch so that hosts connected to these interfaces do not receive BPDUs. If a BPDU is received
on a PortFast edge-enabled interface, the interface loses its PortFast edge-operational status, and BPDU
filtering is disabled.
Enabling BPDU filtering on an interface without also enabling the PortFast edge feature keeps the interface
from sending or receiving BPDUs.
Enabling BPDU filtering on an interface is the same as disabling spanning tree on it and can result in
spanning-tree loops.
Caution
You can enable the BPDU filtering feature for the entire switch or for an interface.
Related Topics
Enabling BPDU Filtering , on page 305
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
289
Information About Optional Spanning-Tree Features

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000