Cisco Catalyst 2960 Series User Manual

CHAPTER 8
Configuring PoE
•
Finding Feature Information, page 85
•
Restrictions for PoE, page 85
•
Information about PoE, page 86
•
How to Configure PoE, page 91
•
Monitoring Power Status, page 100
•
Configuration Examples for Configuring PoE, page 100
•
Additional References, page 101
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for PoE
This feature is supported only on the LAN Base image.Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
85

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000