Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Exits global configuration mode and returns to privileged
EXEC mode.
end
Example:
Device(config)# end
Step 4
Requesting Signed Certificates
You must obtain a signed certificate from the certification authority (CA) for each of the RSA key pairs on
your device. If you generated general-purpose RSA keys, your device has only one RSA key pair and needs
only one certificate. If you previously generated special-usage RSA keys, your device has two RSA key pairs
and needs two certificates.
Perform the following task to request signed certificates from the CA:
If your device reboots after you have issued the crypto pki enroll command, but before you have received
the certificates, you must reissue the command and notify the CA administrator.
Note
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
crypto pki enroll number
4.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Example:
Device> enable
Step 1
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Obtains certificates for your device from the CA.
crypto pki enroll number
Example:
Device(config)# crypto pki enroll myca
Step 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1152
How to Configure Certification Authority

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000