Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Verifies that IGMP report suppression is disabled.show ip igmp snooping
Example:
Switch# show ip igmp snooping
Step 5
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 6
Related Topics
IGMP Report Suppression, on page 122
Configuring MVR Global Parameters
You do not need to set the optional MVR parameters if you choose to use the default settings. If you want to
change the default parameters (except for the MVR VLAN), you must first enable MVR.
For complete syntax and usage information for the commands used in this section, see the command
reference for this release.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
146
How to Configure IGMP Snooping and MVR

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000