Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the recipient of the trap message.
snmp-server host host-addr {traps | informs}
{version {1 | 2c | 3}} community-string
notification-type
Step 3
•
host-addr—Specifies the name or address of the NMS.
Example:
Switch(config)# snmp-server host
•
traps (the default)—Sends SNMP traps to the host.
•
informs—Sends SNMP informs to the host.
•
version—Specifies the SNMP version to support. Version
1, the default, is not available with informs.
172.20.10.10 traps private mac-notification
•
community-string—Specifies the string to send with the
notification operation. Though you can set this string by
using the snmp-server host command, we recommend that
you define this string by using the snmp-server community
command before using the snmp-server host command.
•
notification-type—Uses the mac-notification keyword.
Enables the switch to send MAC address move notification traps
to the NMS.
snmp-server enable traps mac-notification move
Example:
Switch(config)# snmp-server enable traps
Step 4
mac-notification move
Enables the MAC address move notification feature.mac address-table notification mac-move
Example:
Switch(config)# mac address-table
Step 5
notification mac-move
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 6
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 7
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1547
How to Administer the Switch

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000