Cisco Catalyst 2960 Series User Manual

packet and no other packets. Because there is a match clause for IP packets in the VLAN map, the default
action is to drop any IP packet that does not match any of the match clauses.
Switch(config)# ip access-list extended ip1
Switch(config-ext-nacl)# permit tcp any any
Switch(config-ext-nacl)# exit
Switch(config)# vlan access-map map_1 10
Switch(config-access-map)# match ip address ip1
Switch(config-access-map)# action drop
Example: Creating an ACL and a VLAN Map to Permit a Packet
This example shows how to create a VLAN map to permit a packet. ACL ip2 permits UDP packets and any
packets that match the ip2 ACL are forwarded. In this map, any IP packets that did not match any of the
previous ACLs (that is, packets that are not TCP packets or UDP packets) would get dropped.
Switch(config)# ip access-list extended ip2
Switch(config-ext-nacl)# permit udp any any
Switch(config-ext-nacl)# exit
Switch(config)# vlan access-map map_1 20
Switch(config-access-map)# match ip address ip2
Switch(config-access-map)# action forward
Example: Default Action of Dropping IP Packets and Forwarding MAC Packets
In this example, the VLAN map has a default action of drop for IP packets and a default action of forward
for MAC packets. Used with standard ACL 101 and extended named access lists igmp-match and tcp-match,
the map will have the following results:
•
Forward all UDP packets
•
Drop all IGMP packets
•
Forward all TCP packets
•
Drop all other IP packets
•
Forward all non-IP packets
Switch(config)# access-list 101 permit udp any any
Switch(config)# ip access-list extended igmp-match
Switch(config-ext-nacl)# permit igmp any any
Switch(config-ext-nacl)# permit tcp any any
Switch(config-ext-nacl)# exit
Switch(config)# vlan access-map drop-ip-default 10
Switch(config-access-map)# match ip address 101
Switch(config-access-map)# action forward
Switch(config-access-map)# exit
Switch(config)# vlan access-map drop-ip-default 20
Switch(config-access-map)# match ip address igmp-match
Switch(config-access-map)# action drop
Switch(config-access-map)# exit
Switch(config)# vlan access-map drop-ip-default 30
Switch(config-access-map)# match ip address tcp-match
Switch(config-access-map)# action forward
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1258
Configuration Examples for ACLs and VLAN Maps

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000