Cisco Catalyst 2960 Series User Manual

number of directly-connected IPv4 hosts: 0.875k
number of indirect IPv4 routes: 80
number of IPv6 multicast groups: 0.25K
number of directly-connected IPv6 addresses: 0.75K
number of indirect IPv6 unicast routes: 32
number of IPv4 policy based routing aces: 0
number of IPv4/MAC qos aces: 0.375k
number of IPv4/MAC security aces: 0.375k
number of IPv6 policy based routing aces: 0
number of IPv6 qos aces: 0.125k
number of IPv6 security aces: 0.25K
Switch#
Examples: Configuring SDM Templates
This example shows how to configure the VLAN template:
Switch(config)# sdm prefer lanbase-routing
Switch(config)# exit
Switch# reload
Proceed with reload? [confirm]
Switch(config)# sdm prefer dual-ipv4-and-ipv6 default
Switch(config)# exit
Switch# reload
Proceed with reload? [confirm]
Additional References for SDM Templates
Related Documents
Document TitleRelated Topic
Catalyst 2960-X Switch System Management
Command Reference
SDM commands
Standards and RFCs
TitleStandard/RFC
—
None
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1595
Additional References for SDM Templates

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000