Cisco Catalyst 2960 Series

PurposeCommand or Action
◦ tx—Monitors sent traffic.
Specifies the RSPAN session, the destination RSPAN VLAN, and the
destination-port group.
monitor session session_number destination
remote vlan vlan-id
Step 5
Example:
Switch(config)# monitor session 1
destination remote vlan 100
•
For session_number, enter the number defined in Step 4.
•
For vlan-id, specify the source RSPAN VLAN to monitor.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 6
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 7
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 8
startup-config
Related Topics
Remote SPAN, on page 475
RSPAN VLAN, on page 481
RSPAN Configuration Guidelines, on page 483
Specifying VLANs to Filter
Follow these steps to configure the RSPAN source session to limit RSPAN source traffic to specific VLANs.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
494
How to Configure SPAN and RSPAN