Cisco Catalyst 2960 Series User Manual

Example: Specifying a Redirection URL for Successful Login
Configuring redirection URL for successful login
Switch(config)# ip admission proxy http success redirect www.cisco.com
Verifying redirection URL for Successful Login
This example shows how to configure a redirection URL for successful login:
Switch# show ip admission status
Enabled interfaces 0
Total sessions 0
Init sessions 0 Max init sessions allowed 100
Limit reached 0 Hi watermark 0
TCP half-open connections 0 Hi watermark 0
TCP new connections 0 Hi watermark 0
TCP half-open + new 0 Hi watermark 0
HTTPD1 Contexts 0 Hi watermark 0
Parameter Map: Global
Custom Pages
Custom pages not configured
Banner
Banner not configured
Additional References for Web-Based Authentication
Related Documents
Document TitleRelated Topic
Cisco IOS Master Command List, All Releases
Cisco IOS commands
Cisco IOS Identity-Based Networking Services
Command Reference
IBNS commands
Wired Guest Access chapter
Wired guest access
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1451
Additional References for Web-Based Authentication

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000