Cisco Catalyst 2960 Series

PurposeCommand or Action
] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none |
remove vlan_ids | all} ]
Example:
Switch(config-if)# ipv6 nd inspection attach-policy
example_policy
or
Switch(config-if)# ipv6 nd inspection attach-policy
example_policy vlan 222,223,224
or
Switch(config-if)# ipv6 nd inspection vlan 222, 223,224
Verifies that the policy is attached to the specified
interface without exiting the interface configuration
mode.
do show running-config
Example:
Switch#(config-if)# do show running-config
Step 4
Related Topics
Information about First Hop Security in IPv6, on page 678
How to Attach an IPv6 Neighbor Discovery Inspection Policy to a Layer 2 EtherChannel
Interface
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 Neighbor Discovery Inspection
policy on an EtherChannel interface or VLAN:
SUMMARY STEPS
1.
configure terminal
2.
interface range Interface_name
3.
ipv6 nd inspection [attach-policy policy_name [ vlan {vlan_ids | add vlan_ids | except vlan_ids | none
| remove vlan_ids | all} ] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none | remove vlan_ids |
all} ]
4.
do show running-config interfaceportchannel_interface_name
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
690
How to Configure an IPv6 Neighbor Discovery Inspection Policy