Cisco Catalyst 2960 Series User Manual

DescriptionSubevent Type
Type of wdsysmon subevent.type
Name of the node that the POSIX process is on.node
POSIX process name for this subevent.procname
POSIX process ID for this subevent.
The three fields above describe the process
whose CPU utilization is being monitored.
Note
pid
If the sec and msec variables are specified as 0 or are
unspecified in the event registration Tcl command
extension, the process CPU utilization is in the latest
sample. If a time window is specified and is greater
than zero in the event registration Tcl command
extension, the averaged process CPU utilization is in
the given time window.
value
If the sec and msec variables are specified as 0 or are
unspecified in the event registration Tcl command
extension, they are both 0. If a time window is
specified and is greater than zero in the event
registration Tcl command extension, the sec and msec
variables are the actual time difference between the
time stamps of the oldest and latest samples in this
time window.
sec msec
For cpu_tot Subevent
"{type %s node {%s} value %u sec %ld msec %ld}"
DescriptionSubevent Type
Type of wdsysmon subevent.type
Name of the node on which the total CPU utilization
is being monitored.
node
If the sec and msec variables are specified as 0 or are
unspecified in the event registration Tcl command
extension, the total CPU utilization is in the latest
sample. If a time window is specified and is greater
than zero in the event registration Tcl command
extension, the averaged total CPU utilization is in the
given time window.
value
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1968
event_register_wdsysmon

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000