DescriptionEvent Type
The time remaining until the cdp cache entry expires
and is deleted from the cdp table. This time will be
reset to some maximum by an update from the cdp
neighbor. It is usually set to 0 for new entries.
nd_cdp_hold_time
The CDP VTP management domain.nd_cdp_mgmt_domain
The platform name reported by the remote device.nd_cdp_platform
The version of code running on the remote device.nd_cdp_version
The contents of the CDP capabilities field in a string
format: Router, Trans-Bridge, Source-Route-Bridge,
Switch, Host, IGMP, Repeater, Phone,
Remotely-Managed device, CVTA phone port,
Two-port Mac Relay or any combination of these
separated by commas.
nd_cdp_capabilities_string
The CDP capabilities bits in a hexadecimal number
preceded with 0x.
nd_cdp_capabilities_bits
A series of values that will be set to YES if that bit
in the capabilities field is set or NO if it is not set.
nd_cdp_capabilities_bit_[0-31]
LLDP-specific Event_reqinfo
Identifies which protocol triggered the event, for
LLDP it will always be set to lldp.
nd_protocol
Identifies which type of protocol event triggered the
event, add, update or delete.
nd_proto_notif
If set to 1, the event was triggered because the cache
entry is new, otherwise it will be set to 0.
nd_proto_new_entry
The chassis id field from the LLDP cache entry.nd_lldp_chassis_id
The system name from the LLDP cache entry.nd_lldp_system_name
The system description field from the LLDP cache
entry.
nd_lldp_system_description
The LLDP time to live field from the LLDP cache
entry.
nd_lldp_ttl
The port description field from the LLDP cache entry.nd_lldp_port_description
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1909
event_register_neighbor_discovery
To Next Page
Loading...
Need help?
General
