Cisco Catalyst 2960 Series

Set _cerrno
No
Event_reqinfo For EEM_EVENT_MAT
"event_id %u event_type %u event_type_string {%s} event_pub_sec %u event_pub_msec %u
event_severity %u notification %u intf_name %u mac_address {%s}"
DescriptionEvent Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id.
event_id
Type of event.event_type
An ASCII string that represents the name of the event
for this event type.
event_type_string
The time, in seconds and milliseconds, at which the
event was published to the EEM.
event_pub_sec event_pub_msec
The severity of the event.event_severity
Notification type--add or delete.notification
The interface name for the address table entry.intf_name
The mac-address for the address table entry.mac_address
event_register_neighbor_discovery
Registers for a neighbor discover event. Use this Tcl command extension to generate an event when a Cisco
Discovery Protocol (CDP) or Link Layer Discovery Protocol (LLDP) cache entry or a interface link status
changes.
Syntax
event_register_neighbor_discovery [tag ?] interface ?
[cdp {add | update | delete | all}]
[lldp {add | update | delete | all}]
[link-event]
[line-event]
[queue_priority {normal | low | high | last}]
[maxrun ?] [nice {0 | 1}]
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1905
event_register_neighbor_discovery