EasyManuals Logo

Cisco Catalyst 2960 Series User Manual

Cisco Catalyst 2960 Series
2288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1560 background imageLoading...
Page #1560 background image
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
switchport block multicast
5.
switchport block unicast
6.
end
7.
show interfaces interface-id switchport
8.
show running-config
9.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the interface to be configured, and enter
interface configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet1/0/1
Step 3
Blocks unknown multicast forwarding out of the port.switchport block multicast
Step 4
Example:
Switch(config-if)# switchport block multicast
Pure Layer 2 multicast traffic as well as
multicast packets that contain IPv6 information
in the header are blocked.
Note
Blocks unknown unicast forwarding out of the port.switchport block unicast
Example:
Switch(config-if)# switchport block unicast
Step 5
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1478
How to Configure Port Blocking

Table of Contents

Other manuals for Cisco Catalyst 2960 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960 Series and is the answer not in the manual?

Cisco Catalyst 2960 Series Specifications

General IconGeneral
LayerLayer 2
Power over Ethernet (PoE)Available on some models
RAM128 MB
Flash Memory32 MB
MAC Address Table Size8000
Operating Temperature0°C to 45°C (32 to 113°F)
Ports24 or 48 x 10/100/1000

Related product manuals