CHAPTER 26
Configuring NetFlow Lite
•
Finding Feature Information, page 509
•
Prerequisites for NetFlow Lite, page 509
•
Restrictions for NetFlow Lite, page 510
•
Information About NetFlow Lite, page 511
•
How to Configure NetFlow Lite, page 520
•
Monitoring Flexible NetFlow, page 533
•
Configuration Examples for NetFlow Lite, page 534
•
Additional References, page 535
•
Feature Information for Flexible NetFlow, page 536
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Prerequisites for NetFlow Lite
NetFlow Lite is only supported on a Catalyst 2960-X Switch with a LAN Base license and on a Catalyst
2960-XR Switch with an IP Lite license. Catalyst 2960-XR is not stackable with the Catalyst 2960-X platform.
The following two targets for attaching a NetFlow Lite monitor are supported:
• Port—Monitor attachment is only supported on physical interfaces and not on logical interfaces, such
as EtherChannels. The physical interface could be a routed port or a switched port.
• VLAN—Monitor attachment is supported on VLAN interfaces only (SVI) and not on a Layer 2 VLAN.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
509
To Next Page
Loading...
