Example: Removing a VLAN from a Port
This example shows how to remove VLAN 2 from the allowed VLAN list on a port:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport trunk allowed vlan remove 2
Switch(config-if)# end
Where to Go Next
After configuring VLAN trunks, you can configure the following:
•
VLANs
Additional References
Related Documents
Document TitleRelated Topic
Catalyst 2960-X Switch VLAN Management
Command Reference
For complete syntax and usage information for the
commands used in this chapter.
Standards and RFCs
TitleStandard/RFC
——
MIBs
MIBs LinkMIB
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
All supported MIBs for this release.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2149
Where to Go Next
To Next Page
Loading...
