Cisco Catalyst 2960 Series User Manual

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Creates a user profile.
aaa user profile profile-name
Example:
Device(config)# aaa user profile profilename1
Step 3
Adds DNIS or CLID attribute values to the user profile and
enters AAA-user configuration mode.
aaa attribute {dnis | clid}
Example:
Device# configure terminal
Step 4
Exit Global Configuration mode.exit
Step 5
Associates a DNIS or CLID named user profile with the
record sent to the RADIUS server.
test aaa group {group-name | radius} username
password new-code [profile profile-name]
Step 6
Example:
Device# test aaa group radius secret new-code
profile profilename1
The profile-name must match the profile-name
specified in the aaa user profile command.
Note
Verifying the Enhanced Test Command Configuration
To verify the Enhanced Test Command configuration, use the following commands in privileged EXEC mode:
PurposeCommand
Displays information associated with RADIUS.
Device# debug radius
Displays the contents of the current running
configuration file. (Note that the more
system:running-config command has replaced the
show running-config command.)
Devie# more system:running-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
939
How to Configure RADIUS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000