Cisco Catalyst 2960 Series User Manual

(Mandatory) The event-type (create, delete, update)
at which the event is rearmed to be monitored again.
exit_event_type
(Mandatory) Specifies the event and its attributes to
monitor. Valid values are event1, event2, event3,
and event4.
The subevent keywords can be used alone, together,
or in any combination with each other, but each
keyword can be used only once.
event1- event4
(Optional) Maximum run time of the script (specified
in SSSSSSSSSS[.MMM] format, where SSSSSSSSSS
must be an integer representing seconds between 0
and 4294967295, inclusive, and where MMM must
be an integer representing milliseconds between 0
and 999). If this argument is not specified, the default
20-second run-time limit is used.
maxrun
(Optional) Policy run-time priority setting. When the
nice argument is set to 1, the policy is run at a
run-time priority that is less than the default priority.
The default value is 0.
nice
Subevent Syntax
field ? rate_interval ? event1 only entry_value ? entry_op eq|ge|gt|le|lt|wc
[exit_value ?] [exit_op eq|ge|gt|le|lt|wc] [exit_rate_interval ? event1 only]
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1911
event_register_nf

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000