Cisco Catalyst 2960 Series User Manual

Syntax
event_register_snmp_object oid ?
type {int|uint|counter|counter64|gauge|ipv4||oid|string}
sync {yes|no}
skip {yes|no}
[istable {yes|no}]
[default ?]
[queue_priority {normal|low|high|last}]
[maxrun ?]
[nice {0|1}]
Arguments
(Mandatory) OID number of the data element in
SNMP dot notation (for example, 1.3.6.1.2.1.2.1.0).
If the specified OID ends with a dot (.), then all OIDs
that start with the OID number before the dot are
matched. The types of OIDs allowed are:
•
COUNTER_TYPE
•
COUNTER_64_TYPE
•
GAUGE_TYPE
•
INTEGER_TYPE
•
OCTET_PRIM_TYPE
•
OPAQUE_PRIM_TYPE
•
TIME_TICKS_TYPE
oid
(Mandatory) OID value type.type
(Mandatory) A "yes" means that the EEM policy will
be notified. If the applet set_exit_status or Tcl return
value is 0, then SNMP will handle the request. If the
return value is 1, SNMP will use the value provided
by the policy for the get request and will not process
the set request. A "no" means that EEM will not be
notified and SNMP will handle the request.
Only one OID can be associated with a synchronous
policy. However, multiple synchronous policies can
be registered for the same OID.
sync
Mandatory if the sync argument is "no" and should
not exist if the sync argument is "yes." If the skip
argument is "yes," it means that SNMP will handle
the request. If the skip argument is "no," it means that
SNMP will act as if the object does not exist.
skip
(Optional) A value of "no" means the OID is scalar
object, and "yes" means the OID is table object.
istable
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1942
event_register_snmp_object

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000