CHAPTER 4
Configuring Ethernet Management Port
•
Finding Feature Information, page 51
•
Prerequisites for Ethernet Management Ports, page 51
•
Information about the Ethernet Management Port, page 51
•
How to Configure the Ethernet Management Port, page 53
•
Additional References, page 54
•
Feature Information for Ethernet Management Ports, page 55
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Ethernet Management Ports
When connecting a PC to the Ethernet management port, you must first assign an IP address.
Information about the Ethernet Management Port
The Ethernet management port, also referred to as the Fa0 or fastethernet0 port, is a Layer 3 host port to
which you can connect a PC. You can use the Ethernet management port instead of the switch console port
for network management. When managing a switch stack, connect the PC to the Ethernet management port
on a stack member.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
51
To Next Page
Loading...
Need help?
General
