PurposeCommand or Action
Example:
Switch(config-sg-radius)# ignore
For more information about the ignore command, see the Cisco
IOS Intelligent Services Gateway Command Reference on
Cisco.com.
server-key
(Optional) Configures the switch to ignore a CoA request to
temporarily disable the port hosting a session. The purpose of
authentication command bounce-port ignore
Example:
Switch(config-sg-radius)# authentication
Step 11
temporarily disabling the port is to trigger a DHCP renegotiation
from the host when a VLAN change occurs and there is no
supplicant on the endpoint to detect the change.
command bounce-port ignore
(Optional) Configures the switch to ignore a nonstandard command
requesting that the port hosting a session be administratively shut
down. Shutting down the port results in termination of the session.
authentication command disable-port ignore
Example:
Switch(config-sg-radius)# authentication
Step 12
Use standard CLI or SNMP commands to re-enable the port.
command disable-port ignore
Returns to privileged EXEC mode.end
Example:
Switch(config-sg-radius)# end
Step 13
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 14
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 15
Monitoring and Troubleshooting CoA Functionality
The following Cisco IOS commands can be used to monitor and troubleshoot CoA functionality on the switch:
•
debug radius
•
debug aaa coa
•
debug aaa pod
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
975
How to Configure RADIUS Change-of-Authorization
To Next Page
Loading...
