Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Exits out of IPv6 Source Guard policy configuration mode.end
Example:
Switch(config-sisf-sourceguard)# end
Step 5
Shows the policy configuration and all the interfaces where the
policy is applied.
show ipv6 source-guard policy policy_name
Example:
Switch# show ipv6 source-guard policy
example_policy
Step 6
What to Do Next
Apply the IPv6 Source Guard policy to an interface.
Related Topics
Information about First Hop Security in IPv6, on page 678
How to Attach an IPv6 Source Guard Policy to an Interface
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface Interface_type stack/module/port
4.
ipv6 source-guard [attach-policy <policy_name> ]
5.
show ipv6 source-guard policy policy_name
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
706
How to Configure IPv6 Source Guard

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000