Example:
The prompts in the setup program vary depending on the member switch that you selected to be the
command switch:
Continue with configuration dialog? [yes/no]: y
or
Configuring global parameters:
If this prompt does not appear, enter enable, and press Return. Enter setup, and press Return to start the setup program.
Step 11
Respond to the questions in the setup program.
When prompted for the hostname, it is limited to 28 characters and 31 characters on a member switch. Do not use -n,
where n is a number, as the last characters in a hostname for any switch. When prompted for the Telnet (virtual terminal)
password, it is 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores leading spaces.
Step 12
When prompted for the enable secret and enable passwords, enter the passwords of the failed command switch again.
Step 13
When prompted, make sure to enable the switch as the cluster command switch, and press Return.
Step 14
When prompted, assign a name to the cluster, and press Return.
The cluster name can be 1 to 31 alphanumeric characters, dashes, or underscores.
Step 15
After the initial configuration displays, verify that the addresses are correct.
Step 16
If the displayed information is correct, enter Y, and press Return.
If this information is not correct, enter N, press Return, and begin again at Step 9.
Step 17
Start your browser, and enter the IP address of the new command switch.
Step 18
From the Cluster menu, select Add to Cluster to display a list of candidate switches to add to the cluster.
Replacing a Failed Command Switch with Another Switch
To replace a failed command switch with a switch that is command-capable but not part of the cluster, follow
these steps:
Step 1
Insert the new switch in place of the failed command switch, and duplicate its connections to the cluster members.
Step 2
You can access the CLI by using the console port or, if an IP address has been assigned to the switch, by using Telnet.
For details about using the console port, see the switch hardware installation guide.
Step 3
At the switch prompt, enter privileged EXEC mode.
Example:
Switch> enable
Switch#
Step 4
Enter the password of the failed command switch.
Step 5
Use the setup program to configure the switch IP information. This program prompts you for IP address information and
passwords. From privileged EXEC mode, enter EXEC mode, enter setup, and press Return.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1640
How to Troubleshoot the Software Configuration
To Next Page
Loading...
Need help?
General
