Cisco Catalyst 2960 Series User Manual

Flag that specifies that the process is spawned until
called by the API.
is_hold
Core dumping options.dump_option
Maximum number of core dumping permitted.max_dump_count
Total number of restarts for the process.respawn_count
Number of restart attempts of the process. This count
is reset to zero when the process is successfully
restarted.
fail_count
Number of core dumps performed.dump_count
Seconds and milliseconds in POSIX timer units since
January 1, 1970, which represent the last time the
process was started.
last_respawn_sec last_respawn_msec
Process instance ID.inst_id
Sysmgr process states. One of the following: error,
forced_stop, hold, init, ready_to_run, run, run_rnode,
stop, waitEOltimer, wait_rnode, wait_spawntimer,
wait_tpl.
proc_state
Process run level.level
Last exit status of the process.exit_status
Last exit type.exit_type
Set _cerrno
Yes
sys_reqinfo_proc_all
Queries the information of all POSIX processes. This Tcl command extension is supported only in Software
Modularity images.
Syntax
sys_reqinfo_proc_all
Arguments
None
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2003
sys_reqinfo_proc_all

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000