Cisco Catalyst 2960 Series User Manual

Where to Go Next for Auto-QoS
Review the QoS documentation if you require any specific QoS changes to your auto-QoS configuration.
Additional References for Auto-QoS
Related Documents
Document TitleRelated Topic
Cisco IOS Quality of Service Solutions Command
Reference
For complete syntax and usage information for the
commands used in this chapter.
Error Message Decoder
LinkDescription
https://www.cisco.com/cgi-bin/Support/Errordecoder/
index.cgi
To help you research and resolve system error
messages in this release, use the Error Message
Decoder tool.
Standards and RFCs
TitleStandard/RFC
—
MIBs
MIBs LinkMIB
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
All supported MIBs for this release.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
665
Where to Go Next for Auto-QoS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000