Cisco Catalyst 2960 Series User Manual

DescriptionEvent Type
Total failure count, where testnum is the test number.
For example, tf3 is the EEM built-in variable for the
total failure count of test 3.
tf testnum
Test name, where testnum is the test number. For
example, tn3 is the EEM built-in variable for the
name of test 3.
tn testnum
Test result, where testnum is the test number. For
example, tr6 is the EEM built-in variable for test 6
where test 6 is not a per-port test and not a per-device
test.
The test result is one of the following values:
•
P: diagnostic result Pass
•
F: diagnostic result Fail
•
U: diagnostic result Unknown
tr testnum
Per-device test result, where testnum is the test
number and devnum is the device number. For
example, tr3d20 is the EEM built-in variable for the
test result for test 3, device 20.
The test result is one of the following values:
•
P: diagnostic result Pass
•
F: diagnostic result Fail
•
U: diagnostic result Unknown
tr testnum d devnum
Per-port test result, where testnum is the test number
and portnum is the device number. For example,
tr5p20 is the EEM built-in variable for the test result
for test 3, port 20.
The test result is one of the following values:
•
P: diagnostic result Pass
•
F: diagnostic result Fail
•
U: diagnostic result Unknown
tr testnum p portnum
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1886
event_register_gold

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000