Cisco Catalyst 2960 Series

SUMMARY STEPS
1.
enable
2.
show crypto key mypubkey rsa [keyname]
3.
show crypto key pubkey-chain rsa
4.
show crypto key pubkey-chain rsa [name key-name | address key-address]
5.
show crypto pki certificates
6.
show crypto pki trustpoints
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Example:
Device> enable
Step 1
•
Enter your password if prompted.
Displays the RSA public keys configured on a device.
show crypto key mypubkey rsa [keyname]
Example:
Device# show crypto key mypubkey rsa [keyname]
Step 2
Displays the RSA public keys of the peer that are stored
on a device.
show crypto key pubkey-chain rsa
Example:
Device# show crypto key pubkey-chain rsa
Step 3
Displays the address of a specific key.
show crypto key pubkey-chain rsa [name key-name |
address key-address]
Step 4
Example:
Device# show crypto key pubkey-chain rsa address
209.165.202.129
Displays information about the device certificate, the
certification authority (CA) certificate, and any
registration authority (RA) certificates
show crypto pki certificates
Example:
Device# show crypto pki certificates
Step 5
Displays trustpoints that are configured on a device.show crypto pki trustpoints
Example:
Device# show crypto pki certificates
Step 6
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1159
Monitoring and Maintaining Certification Authority