EasyManuals Logo

Cisco Catalyst 2960 Series User Manual

Cisco Catalyst 2960 Series
2288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1717 background imageLoading...
Page #1717 background image
Procedure with Password Recovery Enabled
If the password-recovery operation is enabled, this message appears:
The system has been interrupted prior to initializing the flash file system. The following
commands will initialize the flash file system, and finish loading the operating system
software:
flash_init
load_helper
boot
Step 1
Initialize the flash file system.
Switch: flash_init
Step 2
If you had set the console port speed to any number other than 9600, it has been reset to that particular speed. Change
the emulation software line speed to match that of the switch console port.
Step 3
Load any helper files.
Switch: load_helper
Step 4
Display the contents of flash memory.
Switch: dir: flash:
Directory of flash:
13 drwx 192 Mar 01 2013 22:30:48
c2960x-universalk9-mz-150-2.EX1/c2960x-universalk9-mz-150-2.EX1.bin
11 -rwx 5825 Mar 01 2013 22:31:59 config.text
16128000 bytes total (10003456 bytes free)
Step 5
Rename the configuration file to config.text.old
This file contains the password definition.
Switch: rename flash: config.text flash: config.text.old
Step 6
Boot up the system.
Switch: boot
You are prompted to start the setup program. Enter N at the prompt.
Continue with the configuration dialog?? [yes/no]: No
Step 7
At the switch prompt, enter privileged EXEC mode.
Switch> enable
Switch#
Step 8
Rename the configuration file to its original name.
Switch# rename flash: config.text.old flash: config.text
Before continuing to Step 9, power on any connected stack members and wait until they have completely
initialized. Failure to follow this step can result in a lost configuration depending on how your switch is set up.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1635
How to Troubleshoot the Software Configuration

Table of Contents

Other manuals for Cisco Catalyst 2960 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960 Series and is the answer not in the manual?

Cisco Catalyst 2960 Series Specifications

General IconGeneral
LayerLayer 2
Power over Ethernet (PoE)Available on some models
RAM128 MB
Flash Memory32 MB
MAC Address Table Size8000
Operating Temperature0°C to 45°C (32 to 113°F)
Ports24 or 48 x 10/100/1000

Related product manuals