Table 9: LLDP-MED TLVs
DescriptionLLDP-MED TLV
LLDP-MED inventory management TLVinventory-management
LLDP-MED location TLVlocation
LLDP-MED network policy TLVnetwork-policy
LLDP-MED power management TLVpower-management
Follow these steps to enable a TLV on an interface:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
lldp med-tlv-select
5.
end
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Switch> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the interface on which you are enabling
LLDP, and enter interface configuration mode.
interface interface-id
Example:
Switch (config)# interface
Step 3
gigabitethernet2/0/1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
66
How to Configure LLDP, LLDP-MED, and Wired Location Service
To Next Page
Loading...
