CHAPTER 22
Configuring Cisco IOS Configuration Engine
•
Finding Feature Information, page 407
•
Prerequisites for Configuring the Configuration Engine, page 407
•
Restrictions for Configuring the Configuration Engine, page 408
•
Information About Configuring the Configuration Engine, page 408
•
How to Configure the Configuration Engine, page 414
•
Monitoring CNS Configurations, page 427
•
Additional References, page 428
•
Feature History and Information for the Configuration Engine, page 429
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring the Configuration Engine
•
Obtain the name of the configuration engine instance to which you are connecting.
•
Because the CNS uses both the event bus and the configuration server to provide configurations to
devices, you must define both ConfigID and Device ID for each configured switch.
•
All switches configured with the cns config partial global configuration command must access the
event bus. The DeviceID, as originated on the switch, must match the DeviceID of the corresponding
switch definition in the Cisco Configuration Engine. You must know the hostname of the event bus to
which you are connecting.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
407
To Next Page
Loading...
Need help?
General
