Cisco Catalyst 2960 Series User Manual

•
The cable for the gigabit link is a solid-core cable.
•
The open-ended cable is not terminated.
When you run TDR, the Switch does not report accurate information in these situations:
•
The cable for the gigabit link is a twisted-pair cable or is in series with a solid-core cable.
•
The link is a 10-megabit or a 100-megabit link.
•
The cable is a stranded cable.
•
The link partner is a Cisco IP Phone.
•
The link partner is not IEEE 802.3 compliant.
Debug Commands
Because debugging output is assigned high priority in the CPU process, it can render the system unusable.
For this reason, use debug commands only to troubleshoot specific problems or during troubleshooting
sessions with Cisco technical support staff. It is best to use debug commands during periods of lower
network traffic and fewer users. Debugging during these periods decreases the likelihood that increased
debug command processing overhead will affect system use.
Caution
All debug commands are entered in privileged EXEC mode, and most debug commands take no arguments.
Related Topics
Redirecting Debug and Error Message Output, on page 1645
Example: Enabling All System Diagnostics, on page 1654
Onboard Failure Logging on the Switch
You can use the onboard failure logging (OBFL) feature to collect information about the Switch. The
information includes uptime, temperature, and voltage information and helps Cisco technical support
representatives to troubleshoot Switch problems. We recommend that you keep OBFL enabled and do not
erase the data stored in the flash memory.
By default, OBFL is enabled. It collects information about the Switch and small form-factor pluggable (SFP)
modules. The Switch stores this information in the flash memory:
• CLI commands—Record of the OBFL CLI commands that are entered on a standalone Switch or a
switch stack member.
• Environment data—Unique device identifier (UDI) information for a standalone Switch or a switch
stack member and for all the connected FRU devices: the product identification (PID), the version
identification (VID), and the serial number.
• Message—Record of the hardware-related system messages generated by a standalone Switch or a
switch stack member.
• Power over Ethernet (PoE)—Record of the power consumption of PoE ports on a standalone Switch
or a switch stack member.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1630
Information About Troubleshooting the Software Configuration

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000