EasyManuals Logo

Cisco Catalyst 2960 Series User Manual

Cisco Catalyst 2960 Series
2288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1976 background imageLoading...
Page #1976 background image
(Optional) The frequency used to collect the samples
(specified in SSSSSSSSSS[.MMM] format, where
SSSSSSSSSS must be an integer representing seconds
between 60 and 4294967295, inclusive, and where
MMM must be an integer representing milliseconds
between 0 and 999). The poll interval value must not
be less than 1 second. The default is 1 second.
poll_interval
(Optional) Number in the range from 1 to 64 used to
calculate the period used for rate-based calculations.
The average-factor value is multiplied by the
poll-interval value to derive the period in
milliseconds. The minimum average factor value is
1.
average-factor
(Optional) Priority level at which the script will be
queued:
queue_priority low--Specifies that the script is
to be queued at the lowest of the three priority
levels.
queue_priority normal--Specifies that the script
is to be queued at a priority level greater than
low priority but less than high priority.
queue_priority high--Specifies that the script is
to be queued at the highest of the three priority
levels.
queue_priority last--Specifies that the script is
to be queued at the lowest priority level.
If more than one script is registered with the
"queue_priority_last" argument set, these scripts will
execute in the order in which the events are published.
The queue_priority argument specifies the
queuing priority, but not the execution
priority, of the script being registered.
Note
If this argument is not specified, the default queuing
priority is normal.
queue_priority
(Optional) Maximum run time of the script (specified
in SSSSSSSSSS[.MMM] format, where SSSSSSSSSS
must be an integer representing seconds between 0
and 4294967295, inclusive, and where MMM must
be an integer representing milliseconds between 0
and 999). If this argument is not specified, the default
20-second run-time limit is used.
maxrun
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1894
event_register_interface

Table of Contents

Other manuals for Cisco Catalyst 2960 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960 Series and is the answer not in the manual?

Cisco Catalyst 2960 Series Specifications

General IconGeneral
LayerLayer 2
Power over Ethernet (PoE)Available on some models
RAM128 MB
Flash Memory32 MB
MAC Address Table Size8000
Operating Temperature0°C to 45°C (32 to 113°F)
Ports24 or 48 x 10/100/1000

Related product manuals