Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to global configuration mode.exit
Example:
Switch(config)# exit
Step 5
Specifies the interface on which you are configuring a network-policy
profile, and enter interface configuration mode.
interface interface-id
Example:
Switch (config)# interface
Step 6
gigabitethernet2/0/1
Specifies the network-policy profile number.
network-policy profile number
Example:
Switch(config-if)# network-policy 1
Step 7
Specifies the network-policy TLV.lldp med-tlv-select network-policy
Example:
Switch(config-if)# lldp med-tlv-select
Step 8
network-policy
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 9
Verifies the configuration.show network-policy profile
Example:
Switch# show network-policy profile
Step 10
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 11
startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
69
How to Configure LLDP, LLDP-MED, and Wired Location Service

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000