CHAPTER 12
Configuring MLD Snooping
This module contains details of configuring MLD snooping
•
Finding Feature Information, page 169
•
Information About Configuring IPv6 MLD Snooping, page 169
•
How to Configure IPv6 MLD Snooping, page 173
•
Displaying MLD Snooping Information, page 181
•
Configuration Examples for Configuring MLD Snooping, page 182
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About Configuring IPv6 MLD Snooping
You can use Multicast Listener Discovery (MLD) snooping to enable efficient distribution of IP Version 6
(IPv6) multicast data to clients and routers in a switched network on the switch. Unless otherwise noted, the
term switch refers to a standalone switch and to a switch stack.
To use IPv6, you must configure the dual IPv4 and IPv6 Switch Database Management (SDM) template
on the switch.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
169
To Next Page
Loading...
Need help?
General
