Cisco Catalyst 2960 Series

12.212.112.011.311.211.111.0DescriptionAttribute
Specifies a
route to be
applied to an
interface.
Used with
service=slip,
service=ppp,
and
protocol=ip.
During
network
authorization,
the route
attribute can
be used to
specify a
per-user
static route,
to be
installed by
TACACS+
as follows:
route=”dst_address
mask
[gateway]”
This
indicates a
temporary
static route
that is to be
applied. The
dst_address,
mask, and
gateway are
expected to
be in the
usual
dotted-decimal
notation,
with the
same
meanings as
in the
familiar ip
route
configuration
command on
a network
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
807
Information About TACACS+