Cisco Catalyst 2960 Series User Manual

DescriptionValueCause Code
PPP LCP negotiation timed out.
Codes 40 through 49 apply to PPP
sessions.
Note
Timeout-PPP-LCP40
PPP LCP negotiation failed.Failed-PPP-LCP-Negotiation41
PPP PAP authentication failed.Failed-PPP-PAP-Auth-Fail42
PPP CHAP authentication failed.Failed-PPP-CHAP-Auth43
PPP remote authentication failed.Failed-PPP-Remote-Auth44
PPP received a Terminate Request from
remote end.
PPP-Remote-Terminate45
Upper layer requested that the session be
closed.
PPP-Closed-Event46
PPP session closed because there were no
NCPs open.
NCP-Closed-PPP47
PPP session closed because of an MP error.MP-Error-PPP48
PPP session closed because maximum
channels were reached.
PPP-Maximum-Channels49
Disconnect due to full terminal server
tables.
Tables-Full50
Disconnect due to full internal resources.Resources-Full51
IP address is not valid for Telnet host.Invalid-IP-Address52
Hostname cannot be validated.Bad-Hostname53
Port number is invalid or missing.Bad-Port54
TCP connection has been reset.
Codes 60 through 67 apply to
Telnet or raw TCP sessions.
Note
Reset-TCP60
TCP connection has been refused by the
host.
TCP-Connection-Refused61
TCP connection has timed out.Timeout-TCP62
TCP connection has been closed.Foreign-Host-Close-TCP63
TCP network is unreachable.TCP-Network-Unreachable64
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
920
Information about RADIUS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000