Cisco IOS Global Configuration CommandBoot Loader CommandVariable
boot config-file flash:/ file-url
Specifies the filename that Cisco IOS uses to
read and write a nonvolatile copy of the system
configuration. This command changes the
CONFIG_FILE environment variable.
set CONFIG_FILE
flash:/ file-url
Changes the filename
that Cisco IOS uses to
read and write a
nonvolatile copy of the
system configuration.
CONFIG_FILE
switch current-stack-member-number
renumber new-stack-member-number
Changes the member number of a stack
member.
set
SWITCH_NUMBER
stack-member-number
Changes the member
number of a stack
member.
SWITCH_NUMBER
switch stack-member-number priority
priority-number
Changes the priority value of a stack member.
set
SWITCH_PRIORITY
stack-member-number
Changes the priority
value of a stack
member.
SWITCH_PRIORITY
line console 0
speedspeed-value
Configures the baud rate.
set BAUD baud-rate
BAUD
boot enable-break switch yes/no
This command can be issued when the flash
filesystem is initialized when
ENABLE_BREAK is set to yes.
set
ENABLE_BREAK
yes/no
ENABLE_BREAK
Environment Variables for TFTP
When the switch is connected to a PC through the Ethernet management port, you can download or upload a
configuration file to the boot loader by using TFTP. Make sure the environment variables in this table are
configured.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1568
Information About Performing Switch Setup Configuration
To Next Page
Loading...
