Cisco Catalyst 2960 Series

PurposeCommand or Action
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 6
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 7
Applying a MAC ACL to a Layer 2 Interface
Follow these steps to apply a MAC access list to control access to a Layer 2 interface:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
mac access-group {name} {in | out }
5.
end
6.
show mac access-group [interface interface-id]
7.
show running-config
8.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1250
How to Configure VLAN Access Control Lists