Cisco Catalyst 2960 Series User Manual

DETAILED STEPS
PurposeCommand or Action
Monitors and terminates authenticated client connections using SNMP.Device (config)# aaa session-mib disconnect
Step 1
To terminate the call, the disconnect keyword must be used.
Configuring VRRS Accounting
Perform the following task to configure Virtual Router Redundancy Service (VRRS) to send AAA Accounting
messages to the AAA server:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
aaa accounting vrrs {default | list-name} start-stop method1 [method2...]
4.
aaa attribute list list-name
5.
attribute type name value [service service] [protocol protocol][mandatory][tag tag-value]
6.
exit
7.
vrrs vrrs-group-name
8.
accounting delay seconds
9.
accounting method {default | accounting-method-list}
10.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Enables AAA accounting for VRRS.
aaa accounting vrrs {default | list-name} start-stop
method1 [method2...]
Step 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1025
How to Configure Accounting

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000