What to Do Next
To disable access for an SNMP community, set the community string for that community to the null string
(do not enter a value for the community string).
To remove a specific community string, use the no snmp-server community string global configuration
command.
You can specify an identification name (engine ID) for the local or remote SNMP server engine on the switch.
You can configure an SNMP server group that maps SNMP users to SNMP views, and you can add new users
to the SNMP group.
Related Topics
SNMP Community Strings, on page 449
Configuring SNMP Groups and Users
You can specify an identification name (engine ID) for the local or remote SNMP server engine on the switch.
You can configure an SNMP server group that maps SNMP users to SNMP views, and you can add new users
to the SNMP group.
Follow these steps to configure SNMP groups and users on the switch.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
snmp-server engineID {local engineid-string | remote ip-address [udp-port port-number] engineid-string}
4.
snmp-server group group-name {v1 | v2c | v3 {auth | noauth | priv}} [read readview] [write writeview]
[notify notifyview] [access access-list]
5.
snmp-server user username group-name {remote host [ udp-port port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted] [access access-list] [auth {md5 | sha} auth-password] } [priv {des
| 3des | aes {128 | 192 | 256}} priv-password]
6.
end
7.
show running-config
8.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
456
How to Configure SNMP
To Next Page
Loading...
Need help?
General
