Cisco Catalyst 2960 Series User Manual

Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Table 109: Feature Information for Secure Shell Version 2 Support
Feature InformationReleasesFeature Name
The Cisco image was updated to provide
for the automatic generation of SNMP traps
when an SSH session terminates.
This feature was supported on CAT2960,
CAT3560E, CAT3560X, CAT3750,
CAT3750E, CAT3750X, CAT4500.
Cisco IOS XE Release
3.4SG
Secure Shell Version 2 Client and
Server Support
The Secure Shell Version 2 Enhancements
feature includes a number of additional
capabilities such as support for VRF-Aware
SSH, SSH debug enhancements, and DH
Group 14 and Group 16 exchange support.
This feature was supported on CAT2960,
CAT3560E, CAT3560X, CAT3750,
CAT3750E, CAT3750X, CAT4500.
The VRF-Aware SSH feature is
supported depending on your
release.
Note
The following commands were introduced
or modified: debug ip ssh, and ip ssh dh
min size.
Cisco IOS XE Release
3.4SG
Secure Shell Version 2
Enhancements
The Secure Shell Version 2 Enhancements
for RSA Keys feature includes a number of
additional capabilities to support RSA
key-based user authentication for SSH and
SSH server host key storage and
verification.
This feature was supported on CAT2960,
CAT3560E, CAT3560X, CAT3750,
CAT3750E, CAT3750X, CAT4500.
Cisco IOS XE Release
3.4SG
Secure Shell Version 2
Enhancements for RSA Keys
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1114
Feature Information for Secure Shell Version 2 Support

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000