DescriptionValueCause Code
No resources available to handle the call.
Code is sent when the client is unable to
allocate memory (running low on memory).
VPN-No-Resources602
Bad L2TP or L2F control packets.
This code is sent when an invalid control
packet, such as missing mandatory
Attribute-Value pairs (AVP), from the peer
is received. When using L2TP, the code
will be sent after six retransmits; when
using L2F, the number of retransmits is
user configurable.
VPN-Tunnel-Shut will be sent if
there are active sessions in the
tunnel.
Note
VPN-Bad-Control-Packet603
Administrative disconnect. This can be the
result of a VPN soft shutdown, which is
when a client reaches maximum session
limit or exceeds maximum hopcount.
Code is sent when a tunnel is brought down
by issuing the clear vpdn tunnel
command.
VPN-Admin-Disconnect604
Tunnel teardown or tunnel setup has failed.
Code is sent when there are active sessions
in a tunnel and the tunnel goes down.
This code is not sent when tunnel
authentication fails.
Note
VPN-Tunnel-Shut605
Call is disconnected by LNS PPP module.
Code is sent when the LNS sends a PPP
terminate request to the client. It indicates
a normal PPP disconnection initiated by
the LNS.
VPN-Local-Disconnect606
VPN soft shutdown is enabled.
Code is sent when a call has been refused
due to any of the soft shutdown restrictions
previously mentioned.
VPN-Session-Limit607
VPN call redirect is enabled.VPN-Call-Redirect608
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
922
Information about RADIUS
To Next Page
Loading...
Need help?
General
