Cisco Catalyst 2960 Series User Manual

DescriptionEnvironment Variable
Watchdog System Monitor (WDSysMon) Event
Detector
A value to indicate whether subevent 1 or subevent
2 is present. A value of 1 means that the subevent is
present; a value of 0 means that the subevent is not
present.
_wd_sub1_present _wd_sub2_present
The number of subevents present._wd_num_subs
The event type: cpu_proc, cpu_tot, deadlock,
dispatch_mgr, mem_proc, mem_tot_avail, or
mem_tot_used.
_wd_sub1_type _wd_sub2_type
Watchdog System Monitor (WDSysMon) cpu_proc
Subevents
The slot number for the subevent RP reporting node._wd_sub1_node _wd_sub2_node
The time period, in seconds and optional milliseconds,
used for measurement in subevents.
_wd_sub1_period _wd_sub2_period
The process name of subevents._wd_sub1_procname _wd_sub2_procname
The CPU utilization of subevents measured as a
percentage.
_wd_sub1_value _wd_sub2_value
Watchdog System Monitor (WDSysMon) cpu_tot
Subevents
The slot number for the subevent RP reporting node._wd_sub1_node _wd_sub2_node
The time period, in seconds and optional milliseconds,
used for measurement in subevents.
_wd_sub1_period _wd_sub2_period
The CPU utilization of subevents measured as a
percentage.
_wd_sub1_value _wd_sub2_value
Watchdog System Monitor (WDSysMon) deadlock
Subevents
The slot number for the subevent RP reporting node._wd_sub1_entry_ [1-N]_b_node
_wd_sub2_entry_[1-N]_b_node
The process identifier of subevents._wd_sub1_entry_ [1-N]_b_pid
_wd_sub2_entry_[1-N]_b_pid
The process name of subevents._wd_sub1_entry_ [1-N]_b_procname
_wd_sub2_entry_[1-N]_b_procname
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1694
Information About Writing EEM Policies Using the Cisco IOS CLI

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000