CHAPTER 20
Configuring Flex Links and the MAC
Address-Table Move Update Feature
•
Finding Feature Information, page 373
•
Restrictions for Configuring Flex Links and MAC Address-Table Move Update, page 373
•
Information About Flex Links and MAC Address-Table Move Update, page 374
•
How to Configure Flex Links and the MAC Address-Table Move Update Feature, page 380
•
Monitoring Flex Links, Multicast Fast Convergence, and MAC Address-Table Move Update, page 386
•
Configuration Examples for Flex Links, page 387
•
Additional References for Flex Links and MAC Address-Table Move Update, page 391
•
Feature Information for Flex Links and MAC Address-Table Move Update, page 393
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for Configuring Flex Links and MAC Address-Table Move Update
•
This feature is supported only on the LAN Base image.
•
Flex Links are supported only on Layer 2 ports and port channels.
•
You can configure up to 16 backup links.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
373
To Next Page
Loading...
