PurposeCommand or Action
•
(Optional) interval time—Specifies the time between
notifications; valid values are greater than or equal to 120
seconds. The default is 120 seconds.
Switch(config)# mac address-table
notification threshold limit 78
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 7
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 8
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 9
What to Do Next
Adding and Removing Static Address Entries
Follow these steps to add a static address:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
mac address-table static mac-addr vlan vlan-id interface interface-id
4.
end
5.
show running-config
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1550
How to Administer the Switch
To Next Page
Loading...
