Cisco Catalyst 2960 Series User Manual

Result String
None
Set _cerrno
Yes
(_cerr_sub_err = 2) FH_ESYSERR (generic/unknown error from OS/system)
This error means that the operating system reported an error. The POSIX errno value that is reported with the
error should be used to determine the cause of the operating system error.
(_cerr_sub_err = 8) FH_EDUPLICATEKEY (duplicate appl info key)
This error means that the application event detector info key or other ID was a duplicate.
(_cerr_sub_err = 9) FH_EMEMORY (insufficient memory for request)
This error means that an internal EEM request for memory failed.
(_cerr_sub_err = 34) FH_EMAXLEN (maximum length exceeded)
This error means that the object length or number exceeded the maximum.
(_cerr_sub_err = 43) FH_EBADLENGTH (bad API length)
This error means that the API message length was invalid.
counter_modify
Modifies a counter value.
Syntax
counter_modify event_id ? val ? op nop|set|inc|dec
Arguments
(Mandatory) The counter event ID returned by the
register_counter Tcl command extension. Must be
an integer between 0 and 4294967295, inclusive.
event_id
(Mandatory)
Mandatory except when the op nop argument
value combination is specified.
Note
•
If op is set, this argument represents the counter
value that is to be set.
•
If op is inc, this argument is the value by which
to increment the counter.
•
If op is dec, this argument is the value by which
to decrement the counter.
val
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2012
counter_modify

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000