Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 9
What to Do Next
After enabling DHCP port-based address allocation on the switch, use the ip dhcp pool global configuration
command to preassign IP addresses and to associate them to clients.
Monitoring DHCP Server Port-Based Address Allocation
Table 120: Commands for Displaying DHCP Port-Based Address Allocation Information
PurposeCommand
Displays the status and configuration of a specific interface.
show interface interface id
Displays the DHCP address pools.show ip dhcp pool
Displays address bindings on the Cisco IOS DHCP server.show ip dhcp binding
Additional References
Related Documents
Document TitleRelated Topic
IP Addressing: DHCP Configuration Guide, Cisco
IOS XE Release 3S
http://www.cisco.com/en/US/docs/ios-xml/ios/
ipaddr_dhcp/configuration/xe-3s/
dhcp-xe-3s-book.html
DHCP Configuration Information and Procedures
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1287
Configuring DHCP Server Port-Based Address Allocation

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000