Cisco Catalyst 2960 Series

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
Perform one of the following tasks:
•
interface type number
•
ipv6 nd inspection [attach-policy policy_name [ vlan { add | except | none | remove | all} vlan
[ vlan1, vlan2, vlan3...]]]
OR
•
vlan configuration vlan-id
•
ipv6 nd inspection [attach-policy policy_name [ vlan { add | except | none | remove | all} vlan
[ vlan1, vlan2, vlan3...]]]
4.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Step 2
Specifies an interface type and number, and places the
device in interface configuration mode.
Attaches the IPv6 Neighbor Discovery Multicast Policy
to an interface or a VLAN.
Perform one of the following tasks:
Step 3
•
interface type number
•
ipv6 nd inspection [attach-policy policy_name [ vlan
{ add | except | none | remove | all} vlan [ vlan1,
vlan2, vlan3...]]]
OR
•
vlan configuration vlan-id
•
ipv6 nd inspection [attach-policy policy_name [ vlan
{ add | except | none | remove | all} vlan [ vlan1,
vlan2, vlan3...]]]
Exists the interface configuration mode.exit
Step 4
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
693
How to Attach an IPv6 Neighbor Discovery Multicast Suppress Policy on a Device