CHAPTER 14
Configuring IPv6 ACL
•
Finding Feature Information, page 199
•
Information About Configuring IPv6 ACLs, page 199
•
Configuring IPv6 ACLs, page 201
•
Configuration Examples for IPv6 ACL, page 207
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About Configuring IPv6 ACLs
You can filter IP version 6 (IPv6) traffic by creating IPv6 access control lists (ACLs) and applying them to
interfaces similarly to the way that you create and apply IP version 4(IPv4) named ACLs. You can also create
and apply input router ACLs to filter Layer 3 management traffic.
To use IPv6, you must configure the dual IPv4 and IPv6 Switch Database Management (SDM) template
on the switch. You select the template by entering the sdm prefer {default | dual-ipv4-and-ipv6} global
configuration command.
Note
Understanding IPv6 ACLs
A switch image supports two types of IPv6 ACLs:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
199
To Next Page
Loading...
Need help?
General
