•
Secure Shell (SSH)
•
DHCP-based autoconfiguration
•
SMNP (only the ENTITY-MIB and the IF-MIB)
•
IP ping
•
Interface features
◦ Speed—10 Mb/s, 100 Mb/s, and autonegotiation
◦ Duplex mode—Full, half, and autonegotiation
◦
Loopback detection
•
Cisco Discovery Protocol (CDP)
•
DHCP relay agent
•
IPv4 access control lists (ACLs)
Before enabling a feature on the Ethernet management port, make sure that the feature is supported. If
you try to configure an unsupported feature on the Ethernet Management port, the feature might not work
properly, and the switch might fail.
Caution
How to Configure the Ethernet Management Port
Disabling and Enabling the Ethernet Management Port
SUMMARY STEPS
1.
configure terminal
2.
interface fastethernet0
3.
shutdown
4.
no shutdown
5.
exit
6.
show interfaces fastethernet0
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
53
How to Configure the Ethernet Management Port
To Next Page
Loading...
